All products proudly made in the U.S.A.

Hurricane IH

Recent Comments
    Archives
    Categories
    • No categories

    These deluxe internal halyard flagpoles contain a winch mounted inside the flagpole shaft, operable only with a removable crank handle. As the stainless steel cable unwinds from the winch, it passes up through the inside of the flagpole shaft, over the truck sheave to the outside of the shaft, where the retaining ring provides a sliding anchor. A counterweight, heavily coated with neoprene, attached to the retaining ring, allows the halyard to be lowered for fastening or removing the flag. The halyard is then raised completely out of reach of vandals. The improved winch is gearless and self-locking at any point, eliminating the need for a separate brake. This direct
    drive winch provides rapid raising and lowering of the flag with little effort. This new, improved design does not require any welding, thus avoiding discoloration when an anodized finish is desired. No monthly lubrication is needed and this winch system is easily adaptable
    to existing on-site flagpoles.

    • Gold anodized aluminum ball ornament
    • Cast aluminum cleat with mounting screws
    • Cast aluminum revolving truck w/pulley
    • Spun aluminum flash collar
    • Solid braided polypropolene halyard
    • Galvanized steel foundation sleeve
    • Swivel flag snaps w/vinyl snap covers

    windmap

    This map below shows the maximum steady wind expected at an elevation of thirty feet above ground level within a fifty-year period of recurrence. Areas with the same maximum constant or steady wind speed are indicated. Because wind speeds are usually not constant, and gusts are involved, flagpoles ( both flagged and unflagged) are listed in this catalog with a constant wind speed and a 1.3 gust factor. “WARNING” – recommended flag sizes throughout this catalog do not represent a warranty that the flag size shown may be safely flown in all wind speeds. Personal injury, flagpole damage or property damage can occur when flying oversized flags and banners or flying flags in higher winds than recommended. Flagpoles and their associated wind speeds listed assume that ten percent of the overall length of the flagpole is buried per or recommendations at or near ground level. Special engineering may be required for other applications such as wall or roof mounted flagpoles. Contact us for a prompt response regarding any situation that may require special engineering.

    Showing all 20 results

    All products proudly made right here in the U.S.A.
    Site designed and hosted by sralston.com